Feed Equipment
CH
Series Dry Polymer Preparation System
 The
SNF Floquip CH100 Dry Polymer System is specifically designed for
customers that will use up to 100-pounds of dry polymer per day.
Economics, automatic control, dependability and ease of operation are
some of the benefits of this system. Years of experience with dry
polymer preparation combined with the knowledge of the leading
manufacture of water-soluble polymers is incorporated into every
design.
The CH series unit meets the requirements of facilities with limited
space and polymer needs. The entire make-down process in confined onto
two compact modular skids, and your choice of application pump
delivers a properly hydrated and aged polymer solution into the
process.The system
performs the following :
• Meters the dry powder with a volumetric feeder
• Disperses the polymer with a specially designed wetting weir to
prevent agglomerations
• Properly agitates the solution in a mix tank assembly
• Automatically transfers properly hydrated polymer into the solution
tank assembly
• Controls level limits inside both tank modules
• Provides automation utilizing a small discrete (PLC) Programmable
Logic Controller
• Protects equipment with a low water flow set point
Modular designs allow for various configurations, such as:
• Optional hopper design
• Safety stairs with rails
• Site specific application pump
* Consult your SNF Floquip Engineering Representative
for unit sizing for an entire system from bulk delivery to the
application point.
System Parameters
• 6.0 – 100 pounds/day (2 – 45 kg/day)
• 0.125 – 1.25 pounds/minute dry polymer feed rate (0.06-0.60 kg/minute)
Features
• Simple Installation and Operation
• Polymer wetting weir
• Polymer mixing and application tanks
• Low water flow protection
• Manual and Automatic operation
• Modular system
Utilities
• 15-30 GPM (56-113 L/min) required dilution water"
• 220V, 30A single phase power requirement
* Using 48 lbs/cu.ft. and a 0.25% concentration for
high molecular weight, anionic powders. Process capacity is based on
specific tank sizes and age times. Consult your local polymer sales
representative for chemical specifications.
|
C |
H |
100 |
1 |
S |
| |
H - Hopper for 50 lb (25 kg) sacks |
|
1- (1) Mix Tank, (1) Application Tank |
S – Electric Solenoid Valve |
|
CH - 100
Weight: 1171 pounds (532 kg)
Dimensions: (L x W x H)
System mixing tank assembly
5’ (1525mm)
x 5’ (1525mm)
x 6.5’(1982mm)
System application tank assembly
4’(1220mm)
5’(1525mm)
x 5’(1525mm)
Connections:
Water – 1.0” NPT
Solution – 2.0” NPT |
 |
|
|
Front View |
|
Side View |
|
