Feed Equipment
ML
Series Mannich Preparation Systems
 Mannich
Preparation Systems are designed for dependable operation. Years of
field experience with Mannich preparation, combined with the
knowledge
of the leading manufacturer of water-soluble polymers, is
incorporated into every design.
The ML series is
specifically designed for this cost-effective polymer. The Mannich
is metered, with a progressive cavity pump, through our specially
designed FLOBORE injection device for viscosity equalization into
the dilution water. The result is a solution that is ready to send
to a polymer solution tank for further mixing, then into the
process. The system performs the following:
Meters the high-viscosity neat Mannich
Hydraulically disperses the product in the FLOBORE injection
device
Mechanically shears the Solution for proper preparation
Transfers the Solution to a solution tank
Options:
Ratio Control of the polymer to the incoming water flow
Allen-Bradley
PLC and
Panelview Touchscreen Operator Interface**
Various Tank Configurations
Air Compressor if plant air is not available
* Consult your SNF Floquip Representative for system
size.
** Allen-Bradley PLC and Panelview are registered trademarks of
Rockwell Automation.
System Parameters
ML40
10-40 gpm (37-150 L/min) Primary
Dilution Water
2.5-4.0 gpm (9.4-16 L/min) of Mannich polymer *
ML100
50-100 gpm (190-380 L/min)
Primary Dilution Water
2.5-10 gpm (9.4-38 L/min) of Mannich polymer*
Features
Simple Installation and Operation
Flobore Mannich Injection Device
Mannich Polymer Flowmeter for calibration
Automatic rinse cycle
Low Water Flow Protection
Manual and Automatic operation
Utilities
10-100 gpm (37-380 L/min), 30-50
psi (2.0-3.5 bar) required primary dilution water
480V, 3 phase, 60 Hertz required for preparation unit
80 psi (5.5 bar), 10 scfm instrument air required. Integral air
compressor optional.
* Consult your local polymer
sales representative for chemical specifications.
|
M |
L |
100 |
P |
0 |
| |
|
40 - 40 GPM
flowrate maximum
100 - 100 GPM flowrate maximum |
P - Progressive cavity pump (standard) |
0 - No ratio
control (standard)
RC1 - Open loop control
RC2 - Closed loop control |
|
ML-100
Weight:
821 lb (373 kg)
Dimensions: (L x W x H)
4 (1220mm)
x 4.67(1420mm)
x 5.33 (1625mm)
Connections:
Water - 2 NPT
Solution - 2 NPT
Polymer - 2 Flanged
Air - 1/4 FNPT |
|
|
|
Front View |
Side View |
|
